LEGRAND CB0433 Manual page 4

Wireless and batteryless control for roller shutters
BACK TO FACTORY MODE (DISASSOCIATION + BACK
6.3
ON CHANNEL 11)
+
While holding the «setup» button on the wireless, batteryless control,
press the button for 5 seconds.
upper
Check that your control is correctly reset by pressing «Up» and then
«Down».
Additional Zigbee documentation is available at «developer.legrand.
com».
7. CARE
Clean the surface with a cloth.
Do not use acetone, tar-removing cleaning agents or trichloroethylene.
Resistant to the following products: Hexane (EN 60669-1), methylated
spirit, soapy water, diluted ammonia, bleach diluted to 10%, window-clea-
ning products, pre-impregnated wipes.
Caution : Always test before using special cleaning products, a prior
test is required
Must not be painted.
8. ACCESSORIES
0 648 71: Repositionable adhesive for wireless control
9. STANDARDS AND APPROVALS
EU DECLARATION
9.1
The undersigned, LEGRAND, declares that the radio-electric equipment
type (CB0433 - CN0433 - CT0433 - 0 677 46L/47L - 0 677 64L - 0 770
55L - 6 000 87L - 7 418 08L/38L/ 68L - 5 744 20/21/22/23) complies with
directive 2014/53/EU.
The full text of the EU declaration of conformity is available on the fol-
lowing website: www.legrand.com/ecatalogue
FCC/IC CONFORMITIES
9.2
FCC ID: 2ACN8-ZLGP1X
This device contains licence-exempt transmitter(s)/receiver(s) that com-
ply with FCC RF and Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) This
device must accept any interference, including interference that may
cause undesired operation of the device.
This device complies with FCC and ISED radiation exposure limits set
forth for general population. This device must not be co-located or ope-
rating in conjunction with any other antenna or transmitter.
FCC Caution: the user that changes or modifications not expressly appro-
ved by the party responsible for compliance could void the user's autho-
rity to operate the equipment.
Fiche technique : S000112531EN-01
5 s
OF CONFORMITY
IC: 12132A-ZLGP1X MODEL : ZLGP12
Mise à jour le : 27/10/2021
Catalog number(s) : CB0433 - CN0433 - CT0433
5 744 20/21/22/23 - 7 418 08L/38L/68L
FCC NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not ins-
talled and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CMIM DECLARATION OF CONFORMITY
9.3
The full text of the CMIM declaration of conformity is available on the
folowing website: www.legrand.com/ecatalogue
UKCA DECLARATION OF CONFORMITY
9.4
Only for Arteor range ;
The full text of the UKCA declaration of conformity is available on the
folowing website: www.legrand.com/ecatalogue
CONNECTIVITY STANDARDS ALLIANCE'S CERTIFICATION
9.5
Model : ZLGP12
Créée le : 28/10/2020
0 676 46L/47L - 0 677 64L
0 770 55L - 6 000 87L
4/4