APRILIA RALLY 50 - 2000 Manual page 57

Extract the battery.
Unscrew and remove the screw (3-Fig. 40), taking
c
the washer.
Handle with care.
During the removal, do not damage the in-
spection cover tangs.
Remove the inspection cover (4-Fig. 40) from its
seat, pulling it in the direction of travel.
c
Carefully read p. 41 (MAINTENANCE).
Handle the painted components with care
and avoid scraping or damaging them.
c
Position the vehicle on the stand.
The operations marked with the symbol
must be carried out on both sides of the
vehicle.
Raise the rubber protection of the rear-view mir-
ror (1).
Unscrew the mirror-holder pin (2) and remove it,
together with the rear-view mirror.
Take the spacer(3).
Unscrew and remove the two screws (4) on the
dashboard.
Unscrew and remove the front screw (5), under
the front part of the fairing.
c
Handle with care. During removal, be
careful and avoid damaging the tangs.
Insert a small-tip screwdriver in the joint of the two
handlebar covers (front and rear), in correspond-
ance with one of the side tangs.
Lever moderately, by raising the edge of the front
handlebar cover (6) and releasing the tang.
Repeat the operation for the other tangs (four up-
per and four lower tangs), acting first on the side
ones and then on the central ones.
Remove the front handlebar cover.
Fig. 41
57