APRILIA ETV MILLE CAPONORD ABS - 2003 Manual page 39

SWITCHING FROM TOTAL TO PARTIAL
MILE ODOMETER
Left display
Press and release the push button SET
◆
(9); the relevant total partial or total miles
traveled will appear on the display.
NOTE
Whenever the ignition key (1) is
turned to the ≈ ∆ (ON) position, the display
always indicates the total number of miles
that the vehicle has traveled since new.
To set the partial miles odometer to ze-
ro, proceed as follows:
◆
Display the partial number of miles cov-
ered, see above.
Press the push button SET (9) for more
◆
than three seconds; the segments (3)
are set to zero.
NOTE
The removal of the battery, or the
removal of the 30A fuses, cause the digital
clock and partial miles odometer to go to
zero.
SETTING THE CLOCK (HOURS AND
MINUTES)
NOTE
The setting of the clock can be
carried out only with the vehicle at rest.
Press the push button MODE (10) for
◆
more than three seconds, the segments
corresponding to the hours (11) will
flash.
NOTE
If the push button SET (9) is
pressed and released, the data are
changed one by one; if the push button
SET (9) is kept pressed, the data change
scrolling quickly and cyclically.
Press the push button SET (9) and se-
◆
lect the desired hour (11).
◆
To confirm the time setting, press and re-
lease the button MODE (10), and the
minute segments (12) will flash.
Press the push button SET (9) and se-
◆
lect the desired minutes (12).
◆
To confirm the minute setting, press and
release the push button MODE (10).
NOTE
The removal of the battery, or the
removal of the 30A fuses, cause the digital
clock and partial miles odometer to go to
zero.
use and maintenance ETV mille Caponord ABS
39