Page 1
Owner’s Manual TYPE ET31-- WARNING FOR YOUR SAFETY – For anything other than the routine cleaning and maintenance described in this guide, this product must be serviced by a qualified professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in the product’s complete installation and operations manual can be followed exactly.
Page 2
Section 1. Important Safety Instructions READ AND FOLLOW ALL INSTRUCTIONS Congratulations on purchasing this Baracuda Cordless Robotic Cleaner. Please read through the entire manual before installing your new cordless robotic pool cleaner. Your cleaner must be installed and operated as specified.
Page 3
• Do not enter pool while the Baracuda cleaner is in water. • To reduce the risk of electrical shock, do not use the Baracuda robotic cleaner or charger if the charger cord is worn or damaged. Contact Baracuda Customer care Service 1300 784 423 immediately for proper servicing and replacement of the damaged cord.
Page 4
• Clean the filter canister after each cleaning cycle. • Do not leave your cleaner in the pool on a permanent basis. • The Baracuda robotic cleaner includes a safety feature that automatically stops the cleaner if it is powered on but not submerged in water.
Page 5
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Set Up Charging Dry the cleaner and charging contacts, then charge the cleaner before every cleaning cycle. The battery Select an indoor charging location (GFCI outlet) indicator slowly blinks orange while charging, slowly at least 3.5 m away from the pool, out of direct...
Page 6
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Starting the Cleaner Submerge the Cleaner Replace the protective cap over the charging port. Start the cleaner by sliding the power switch down OPTIONAL: Attach the and releasing it. floating ring to the handle...
Page 7
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Removal Remove the cleaner from the water using either the hook -OR- the floating ring: Hook Removal Floating Ring Removal Attach the hook provided to a standard pool cleaning Grab the floating ring and pull cleaner toward the pole (not included).
Page 8
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Section 4. Maintenance Replace the filter canister into the cleaner. Charge the Cleaner WARNING Always dry the cleaner and charging contacts To avoid electric shock and other hazards which could result in permanent before charging.
Page 9
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Replacing Wear Parts To install the new brush, position the new brush on the roller with the cleaning blades facing away from 4.4.1 Replacing Brushes the roller. The cleaner is fitted with PVC brushes with a “wear”...
Page 10
Baracuda KLEA Cordless Robotic Cleaner | Owner’s Manual ® ™ Replacing the Tracks Recycling & Disposal Stand the cleaner on its side. The battery and cleaner must be serviced and/or replaced by a qualified service professional. DO NOT attempt to service the product yourself.
Page 11
20 seconds. Then, connect the cleaner to the charger to wake it up. If the problem is not resolved, contact Baracuda Customer Service at 1300 784 423. The cleaner does not fully Dirty charging contacts.
Need help?
Do you have a question about the klea and is the answer not in the manual?
Questions and answers