Vpn Wizard Network Setting; Figure 26 Vpn Wizard: Gateway Setting; Table 15 Vpn Wizard: Gateway Setting - ZyXEL Communications ZYWALL 2 PLUS User Manual

Internet security appliance

Hide thumbs Also See for ZYWALL 2 PLUS:

Table of Contents

The following table describes the labels in this screen.

Gateway Policy

Gateway Policy

3.4 VPN Wizard Network Setting

Use this screen to name the VPN network policy (IPSec SA) and identify the devices behind

the IPSec routers at either end of a VPN tunnel.

ZyWALL 2 Plus User's Guide

Type up to 32 characters to identify this VPN gateway policy. You may use any

character, including spaces, but the ZyWALL drops trailing spaces.

When the ZyWALL is in router mode, enter the WAN IP address or the domain name

of your ZyWALL or leave the field set to 0.0.0.0.

The ZyWALL uses its current WAN IP address (static or dynamic) in setting up the

VPN tunnel if you leave this field as 0.0.0.0. If the WAN connection goes down, the

ZyWALL uses the dial backup IP address for the VPN tunnel when using dial backup

or the LAN IP address when using traffic redirect.

The VPN tunnel has to be rebuilt if this IP address changes.

When the ZyWALL is in bridge mode, this field is read-only and displays the

ZyWALL's IP address.

Enter the WAN IP address or domain name of the remote IPSec router (secure

gateway) in the field below to identify the remote IPSec router by its IP address or a

domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN

Click Back to return to the previous screen.

Click Next to continue.

Chapter 3 Wizard Setup