Figure 268 Maintenance > Device Mode (Router Mode); Table 164 Maintenance > Device Mode (Router Mode) - ZyXEL Communications ZYWALL 2 PLUS User Manual

You can use the firewall and VPN in bridge mode. See the user's guide for a list of other
features that are available in bridge mode.
The following applies when the ZyWALL is in router mode.
Figure 268 MAINTENANCE > Device Mode (Router Mode)
The following table describes the labels in this screen.
Table 164 MAINTENANCE > Device Mode (Router Mode)
LABEL
Current Device
Mode
Device Mode
Device Mode Setup
Router
IP Address
Bridge
IP Address
IP Subnet Mask
Gateway IP
Address
Apply
Reset
ZyWALL 2 Plus User's Guide
DESCRIPTION
This displays whether the ZyWALL is functioning as a router or a bridge.
When the ZyWALL is in router mode, there is no need to select or clear this radio
button.
Click LAN, WAN, DMZ or WLAN to go to the LAN, WAN, DMZ or WLAN screen
where you can view and/or change the corresponding settings.
Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
Enter the IP address of your ZyWALL in dotted decimal notation. Use an IP
address in the same subnet as the network to which you connect the ZyWALL.
Make sure the IP address does not conflict with any other device on the
network.
Enter the IP subnet mask of the ZyWALL.
Enter the gateway IP address.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
Chapter 25 Maintenance
435