Remote Node Setup; Chapter 33 Remote Node Setup; Introduction To Remote Node Setup; Remote Node Profile Setup - ZyXEL Communications ZYWALL 2 PLUS User Manual

C
H A P T E R
This chapter shows you how to configure a remote node.

33.1 Introduction to Remote Node Setup

A remote node is required for placing calls to a remote gateway. A remote node represents
both the remote gateway and the network behind it across a WAN connection. Note that when
you use menu 4 to set up Internet access, you are actually configuring a remote node. The
following describes how to configure Menu 11.1 - Remote Node Profile, Menu 11.1.2 -
Remote Node Network Layer Options and Menu 11.1.4 - Remote Node Filter.

33.2 Remote Node Setup

From the main menu, select menu option 11 to open Menu 11 - Remote Node Setup (shown
below).
Enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your WAN
port. Enter 2 to open Menu 11.2 Remote Node Profile (Backup ISP) and configure the setup
for your Dial Backup port connection (see

Figure 313 Menu 11: Remote Node Setup

33.3 Remote Node Profile Setup

The following explains how to configure the remote node profile menu.
ZyWALL 2 Plus User's Guide

Remote Node Setup

Chapter 28 on page
Menu 11 - Remote Node Setup
1. ChangeMe (ISP, SUA)
2. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit:
33
459).
487