Table 38 Network > Wan > Dial Backup > Edit - ZyXEL Communications ZYWALL 2 PLUS User Manual

Chapter 8 WAN Screens
The following table describes the labels in this screen.
Table 38 NETWORK > WAN > Dial Backup > Edit
LABEL
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout
(sec)
Retry Count
Retry Interval
(sec)
Drop Timeout
(sec)
Call Back Delay
(sec)
Apply
Cancel
160
DESCRIPTION
Type the AT Command string to make a call.
Type the AT Command string to drop a call. "~" represents a one second wait, for
example, "~~~+++~~ath" can be used if your modem has a slow response time.
Type the AT Command string to answer a call.
Select this check box to have the ZyWALL drop the DTR (Data Terminal Ready)
signal after the "AT Command String: Drop" is sent out.
Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyWALL capture the CLID in the AT response string
that comes from the WAN device. CLID is required for CLID authentication.
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed.
Type a number of seconds for the ZyWALL to try to set up an outgoing call before
timing out (stopping).
Type a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Type a number of seconds for the ZyWALL to wait before trying another call after a
call has failed. This applies before a phone number is blacklisted.
Type the number of seconds for the ZyWALL to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.
Type a number of seconds for the ZyWALL to wait between dropping a callback
request call and dialing the corresponding callback call.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL 2 Plus User's Guide