Table of Contents
Advertisement
Chapter 31 PPPoE
The following table describes the labels in this screen.
Table 103 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL
Show VLAN
Start VID
End VID
Apply
VID
*
Enabled
Circuit-id
Remote-id
Apply
Cancel
310
DESCRIPTION
Use this section to specify the VLANs you want to configure in the section
below.
Enter the lowest VLAN ID you want to configure in the section below.
Enter the highest VLAN ID you want to configure in the section below.
Click Apply to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above.
If you configure the * VLAN, the settings are applied to all VLANs.
Use this row to make the setting the same for all VLANs. Use this row first
and then make adjustments on a VLAN-by-VLAN basis.
Note: Changes in this row are copied to all the VLANs as soon as
you make them.
Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Select this option to make the Circuit ID settings for a specific VLAN take
effect.
Select this option to make the Remote ID settings for a specific VLAN take
effect.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS4700-48F User's Guide
Advertisement
Table of Contents
Troubleshooting
