•
All storage arrays—Select this option to send an e-mail alert about
events on all storage arrays.
•
An individual storage array—Select this option to send an e-mail alert
about events that occur on only a specified storage array.
These results occur, depending on your selection:
•
If you selected all storage arrays, the Configure Alerts dialog is
displayed.
If you selected an individual storage array, the Select Storage Array
•
dialog is displayed. Select the storage array for which you want to
receive e-mail alerts and click OK. The Configure Alerts dialog is
displayed.
•
If you do not know which storage array to select, click Blink to turn on
the LEDs of the storage array.
3 In the Configure Alerts dialog, select the Mail Server tab.
4 In Mail Server, type the name of the Simple Mail Transfer Protocol
(SMTP) mail server.
The SMTP mail server is the name of the mail server that forwards the e-
mail alert to the configured e-mail addresses.
5 In Email sender address, type the valid sender e-mail address.
The e-mail address of the sender (the network administrator) is displayed
on each e-mail alert sent to the destination.
6 To include the contact information of the sender in the e-mail alert, select
Include contact information with the alerts, and type the contact
information.
NOTE:
7 Select the E-mail tab to configure the e-mail destinations.
•
Adding an e-mail address—In Email address, type the e-mail address,
and click Add.
•
Replacing an e-mail address—In the Configured email addresses area,
select the e-mail address to be replaced, type the replacement e-mail
address in Email address, and click Replace.
Deleting an e-mail address—In the Configured email addresses area,
•
select the e-mail address, and click Delete.
80
Configuration: About Your Storage Array
Including the contact information in the e-mail alert is optional.