Limitations And Known Issues - Dell POWERVAULT MD3620I Owner's Manual

Table 14-1. Useful Device Mapper Commands
Command
rescan_dm_devs

Limitations and Known Issues

• In certain error conditions with the no_path_retry or the
queue_if_no_path feature is set, applications may hang. To overcome
these conditions, enter the following command for each affected
multipath device:
dmsetup message [device] 0 "fail_if_no_path"
where [device] is the multipath device name (for example, mpath2;
do not specify the path)
• I/O may hang when a Device Mapper device is deleted before the volume
is unmounted.
• If the scsi_dh_rdac module is not included in initrd, slower device
discovery may be seen and the syslog may become populated with buffer
I/O error messages.
• I/O may hang if the host server or storage array is rebooted while I/O is
active. All I/O to the storage array must be stopped before shutting down
or rebooting the host server or storage array.
• After a failed path is restored on an MD3600i Series array, failback does not
occur automatically because the driver cannot auto-detect devices without
a forced rescan. Run the command rescan_dm_devs to force a rescan
of the host server. This restores the failed paths enabling failback to occur.
204
Configuration: Device Mapper Multipath for Linux
Description
Dell provided script. Forces a rescan of the host SCSI bus
and aggregates multipathing devices as needed. For use
when:
• LUNs are dynamically mapped to the hosts.
• New targets are added to the host.
• Failback of the storage array is required.
• For MD3600i Series arrays, iSCSI sessions have to be
established for rescan to take effect.
(continued)