Figure 66 Static Route Setup; Table 50 Static Route Setup - ZyXEL Communications P-320W User Manual

Figure 66 Static Route Setup

The following table describes the labels in this screen.

Table 50 Static Route Setup

LABEL
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Apply
Reset
Chapter 10 Static Route Screens
DESCRIPTION
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate neighbor of
your Prestige that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your Prestige; over the WAN,
the gateway must be the IP address of one of the Remote Nodes.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Click Apply to save your changes back to the Prestige.
Click Reset to start configuring this screen again.
P-320W User's Guide
117