Dell Powerconnect-Kr 8024-K Switch - Dell POWEREDGE M1000E Configuration Manual

3 Select the Setup tab. The Configuring I/O Modules Network Settings
page is displayed.
4 Configure the switch for integration into your network.
– Select DHCP Mode Enabled if your network uses a DHCP server to
assign IP addresses.
– If your network uses static IP addressing, enter an IP address, subnet
mask and gateway.
5 When you have finished, click Apply.
6 Click the Deploy sub-tab.
After all I/O modules have been configured and connected, the enclosure's
blades can be inserted and booted with full network communication.

Dell PowerConnect-KR 8024-k Switch

The PowerConnect M8024-k switch provides 16 internal 10 GbE ports, four
external 10 GbE SFP+ ports, and one 10 GbE expansion slot for 10 GbE
external uplinks. The expansion slot on the front panel can support:
• A 10 Gb Ethernet module with four optical SFP+ connectors
• A 10 Gb Ethernet module with three copper CX4 uplinks
• A 10 Gb Ethernet module with two copper 10GBASE-T uplinks
This module is hot-swappable and may be installed in Fabric A, B, or C.
Configuring the I/O Modules
53