Dell POWEREDGE M1000E Configuration Manual page 45

Component
CMC
NOTE:
Components not appearing in the above table require no updates to enable
the FlexAddress feature.
Activating FlexAddress Plus
FlexAddress Plus is delivered on the FlexAddress Plus Secure Digital (SD)
card along with the FlexAddress feature.
NOTE:
The SD card labeled FlexAddress only contains FlexAddress and the card
labeled FlexAddress Plus contains FlexAddress and FlexAddress Plus. The card
must be inserted into the CMC to activate the feature.
The updates, which are listed in the table below include, BIOS, iDRAC, and
CMC firmware. As long as FlexAddress is activated, you must apply these
updates before you can use FlexAddress Plus. If these updates are not applied,
only FlexAddress works and not FlexAddress Plus.
Component
Server Module BIOS
iDRAC
CMC
For more information on the FlexAddress feature, see the following resources:
• The CMC Secure Digital (SD) Card Technical Specification document at
support.dell.com.
• The Help link in the CMC Web interface.
The "Using FlexAddress" chapter in the CMC User's Guide.
•
Minimum Required Version
Version 1.10 or later
Minimum required version
PowerEdge M710HD
Version 3.0 or later
Version 3.0 or later
Initial System Configuration
45