ZyXEL Communications OMNI 56K User Manual page 52

User's Guide for ZyXEL Omni 56K and Omni 56K Plus Modems
+FLO=n
+FPR=n
+FBO=n
+FEA=n
+FCR=n
+FCQ=<rq>,<tq>
+FRQ=pql,cbl
+FAA=n
+FCT=n
+FMS=n
+FBS?
5-14
Flow Control Select
Serial Port Rate Control
Phase C Data Bit Order
Phase C Received EOL alignment n=0:EOL patterns are as received
Capability to Receive
Copy Quality disable/enable
Receive Quality Thresholds
Adaptive Answer Mode
Phase C Timeout
Minimum Phase C Speed
Buffer Size
n=5:Page is good; procedure
interrupt is requested.
n=0:No flow control
n=1:Sets XON/ XOFF software
flow control
n=2:Sets CTS/RTS hardware flow
control
n=0:Automatic DTE rate detection
by the DCE
n>0:Serial rate is fixed at the value
multiplied by 2400 bps.
n=0:Selects direct bit order
n=1:Selects reversed bit order
n=0:Not receive message data or
poll a remote device.
n=1: Receives message data or
poll a remote device.
rq= 0:Receive copy quality check is
disable.
rq=1:Receive copy quality check is
enable.
tq= 0:Transmit copy quality check
is disable.
tq=1:Transmit copy quality check is
enable.
pgl= 0-64h:Specifies the
percentage of good lines
cbl= 0-ffh:Specifies the maximum
tolerable number of consecutive
bad lines.
n=0:Answers as set by +FCLASS
n=1:Answers and auto-determines
the call type.
n=0-ffh,1 sec units
n=0:2400 bps
n=1:4800 bps
n=2:7200 bps
n=3:9600 bps
n=4:12000 bps
n=5:14400 bps
512,256