Related Manuals for CAMPAGNOLO Bora WTO 60
Summary of Contents for CAMPAGNOLO Bora WTO 60
- Page 1 TECHN ICAL MANUAL - 5 WHEE L S R E MOVAL AND REFITTIN G WH EEL REA R H UB ( CUP-CON E BEAR IN G S) C A M PA G N O L O. CO M C A M PA G N O L O. CO M...
- Page 2 WARNING! Always wear protective gloves and glasses while working on the bicycle. THIS TECHNICAL MANUAL IS INTENDED FOR USE BY PROFESSIONAL MECHANICS. Anyone who is not a qualified professional for bicycle assembly must not attempt to install and operate on the components independently due to the risk of carrying out incorrect operations which could cause the components to malfunction, resulting in accidents, physical injury or even death.
-
Page 3: Techn Ical Manual
Shamal™ Eurus™ Zonda™ Refer to the “Table of Technical Manuals for Wheels”, available at www.campagnolo.com / section “Technical Documentation – Technical Manuals”. Ultra™ Remove the cover from the side of the adjustment ring ►To remove the freewheel body see OPERATION 004 Insert the two hex wrenches inside the hex-drive of the nut with a small flat-bladed screwdriver. - Page 4 PRODUCTS ON WHICH THE PROCEDURE SHOULD BE APPLIED MAINTENANCE Refer to the “Table of Technical Manuals for Wheels”, available at www.campagnolo.com / section “Technical Documentation – Technical Manuals”. ►To replace the spoke see OPERATION 003 (from 1 to Insert the cone on the rear axle following the direction it Check the cone is mates correctly into the bearing should be inserted in.
- Page 5 REMOVAL AND REFITTING WHEEL REAR HUB (CUP-CONE BEARINGS) PRODUCTS ON WHICH THE PROCEDURE SHOULD BE APPLIED Refer to the “Table of Technical Manuals for Wheels”, available at www.campagnolo.com / section “Technical Documentation – Technical Manuals”. MAINTENANCE ►To mount the freewheel body see OPERATION 004...
- Page 6 REMOVAL AND REFITTING WHEEL REAR HUB (CUP-CONE BEARINGS) PRODUCTS ON WHICH THE PROCEDURE SHOULD BE APPLIED Refer to the “Table of Technical Manuals for Wheels”, available at www.campagnolo.com / section “Technical Documentation – Technical Manuals”. • If your wheel has a Quick Release pivot: refer to Technical...
- Page 7 REMOVAL AND REFITTING WHEEL REAR HUB (CUP-CONE BEARINGS) PRODUCTS ON WHICH THE PROCEDURE SHOULD BE APPLIED Refer to the “Table of Technical Manuals for Wheels”, available at www.campagnolo.com / section “Technical Documentation – Technical Manuals”. Screwdriver Remove the left hand adaptor applying pressure outward Loosen the screw which tightens the ring.
Need help?
Do you have a question about the Bora WTO 60 and is the answer not in the manual?
Questions and answers