Wan For Dhcp Client Screen - ZyXEL Communications FSG1100HN User Manual

5.3

WAN for DHCP Client Screen

Dynamic Host Configuration Protocol (DHCP), based on RFC 2131 and RFC 2132,
allows individual clients to obtain TCP/IP configuration at start-up from a server. Users
can configure the FSG1100HN's LAN as a DHCP server or disable it. When
configured as a server, the FSG1100HN provides the TCP/IP configuration for the
clients. If DHCP service is disabled, another DHCP server must be available on that
network, or the computer will need to be manually configured.
Click Networking > WAN > DHCP Client to open the WAN screen for DHCP Client
(the default WAN screen).
Networking > WAN > DHCP Client
The following table describes the WAN DHCP client labels in this screen.
Networking > WAN > DHCP Client
LABEL
WAN Settings
WAN Access Type
Attain DNS
Automatically
Set DNS Manually
DNS1-DNS3
Clone MAC Address
Enable UPnP
Enable IGMP Proxy
FSG1100HN User's Guide
DESCRIPTION
Choose DHCP Client. The other options are Static IP or
PPPoE.
Click to attain DNS automatically. Otherwise, enter DNS
manually using the field below.
Enter the DNS server IP address(es) assigned by the ISP.
Enter the DNS server IP address(es) assigned by the ISP.
Enable MAC address cloning.
Enable the Universal Plug and Play (UPnP) feature.
Plug and Play (UPnP) is a distributed, open networking
standard that uses TCP/IP for simple peer-to-peer network
connectivity between
dynamically join a network, obtain an IP address, convey its
capabilities and learn about other devices on the network. In
turn, a device can leave a network smoothly and
automatically when it is no longer in use.
Enable the IGMP proxy feature. IGMP proxy enables the
device to issue IGMP host messages on behalf of hosts that
Chapter 5 WAN
devices. A UPnP
Universal
device can
49