ZyXEL Communications FSG1100HN Quick Start Manual
Wireless active fiber router
Hide thumbs
Also See for FSG1100HN:
- Quick start manual (18 pages) ,
- Specifications (2 pages) ,
- User manual (183 pages)
Related Manuals for ZyXEL Communications FSG1100HN
Summary of Contents for ZyXEL Communications FSG1100HN
- Page 1 FSG1100HN Wireless Active Fiber Router Multiservice Home Gateway with 802.11n Wireless Firmware V1.00 Edition 3/6/2010 IP Address: http://192.168.1.1 User Login: User Name: admin Password: 1234...
- Page 2 LED and Rear Panel...
- Page 3 Overview The FSG1100HN is a wireless router that lets you set up both wired and wireless networks. Its built-in firewall is enabled by default to protect your network. The Quick Start Guide show you how to: Mount the FSG1100HN on the Wall ...
-
Page 4: Wall-Mounting Instructions
Wall-Mounting Instructions Here have two ways to install FSG1100HN on a wall a.) Wall-mounting Fixing b.) Wall-mounting Hangging. Do the following to “fix“ your FSG1100HN on a wall 1. Locate a high position on a wall that is free of obstructions. - Page 5 5. Plug-in Fiber on module. Make sure the Fiber Cable has coiled the hole as figure showing: 6. Put the Mylar on the Fiber tray to prevent fiber coil derailment...
- Page 6 7. Slide the Upper Case in: 8. For Hagging, don’t screw the screws all the way into the wall. Leave a small gap of about 0.5cm between the heads of the screws and the wall. Make sure the screws are snugly fastened to the wall. They need to...
- Page 7 FSG1100HN with connection cables. The following are dimensions of an M4 tap screw and masonry plug used for wall mounting. All measurements are in millimeters (mm).
- Page 9 1. Make the following hardware connections to your FSG1100HN: Connect the antennas (A) to the antenna sockets, ensuring they are screwed in firmly and angled upwards. Connect the WAN port (B) on your FSG1100HN to the Ethernet port on the device with which you are...
- Page 10 Connect the Ethernet port on your computer to a LAN port (C) on the FSG1100HN using an Ethernet cable. Use the power adapter (D) from the package to connect the POWER socket to an appropriate power source.
- Page 11 FSG1100HN wirelessly. Check if your wireless device has the WPS logo and follow these steps to set up your wireless network using WPS. 1. Make sure your FSG1100HN is turned on (A). Place your wireless device within range of the FSG1100HN.
- Page 12 2. Enable wireless on the FSG1100HN by Wireless holding the button longer 1 sec (B). 3. Press the WPS button on the FSG1100HN and your notebook (B). It doesn’t matter which button is pressed first. You must press the second button within two minutes of pressing the first one.
- Page 16 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.