EGO POWER+ ETA0800E Operator's Manual page 9

TROUBLESHOOTING
PROBLEM
Machine fails to start or stops
unexpectedly.
There is too much noise and/or
vibration during operation.
Motor runs, but auger bit
remains stationary.
The auger rotation direction
or speed is not switched after
pushing the rotation direction/
speed selector.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
CAUSE
◾
Low battery pack capacity.
◾
Battery pack is overheated or
too cold.
◾
The right handle cable is not
connected with the power head
cable properly.
◾
Some parts are loose.
◾
Loose auger bit.
◾
Switching direction of rotation
between forward and reverse is
only possible when the auger is
stopped.
◾
Other unidentified causes.
56V LITHIUM-ION EARTH AUGER BIT — ETA0800E
SOLUTION
◾
Charge the battery pack.
◾
Wait for the battery pack to cool
down or warm up, at which point the
auger can be started again.
◾
Connect the cables of the right
handle and the power head following
the section "INSTALLING THE
HANDLES" in the power head
PHA7400E operator's manual.
◾
Stop the auger, remove the battery
pack, check and tighten loose parts.
◾
Reinstall the auger bit following the
section "INSTALLING THE EARTH
AUGER BIT" in this manual.
◾
Stop the auger completely, push the
rotation direction/speed selector to
desired rotation and then start the
auger again.
◾
Contact EGO service for repair.
EN
9