Fenix HL45R Instruction Manual page 3

Output Selection
White light mode: With the lamp switched on, single click the electronic switch to cycle through
Low→Med→High→Turbo.
Red light mode: In Red light mode, single click the electronic switch to cycle through
Low→Med→High→Flash.
Gesture-sensing Function
On: With the lamp switched off, press and hold the electronic switch for 6 seconds, and the lamp will
flash twice at the Low output of Red light mode, indicating that the function is enabled.
Off: With the lamp switched off, press and hold the electronic switch for 6 seconds, and the lamp will
flash eight times at the Low output of Red light mode, indicating that the function is disabled.
Gesture-sensing lamp on/off
With the lamp turned on and the gesture-sensing function enabled, wave your hand within the sensing
range in front of the lamp to temporarily turn off the lamp, and wave your hand again to turn on the
lamp and recall the last selected output.
With the lamp turned on and the gesture-sensing function disabled, it will not respond to any motion
operation.
*When the lamp is turned on and the gesture-sensing function is enabled, press and hold the electronic
switch for 0.5 seconds to turn off the lamp. After this action, it will not respond to any motion
operation.
Note:
1. The sensing range is within about 3.94in/10cm in front of the lamp, and may vary slightly depending
on the material and color of the sensing object, the ambient light, the brightness of the selected
output, and the waving speed.
2. The gesture-sensing function is infrared sensing. If any other objects besides your hand pass in front
of the lamp within the sensing range, the lamp will also be turned on or off.
3. The gesture-sensing function can only turn the light on and off within the current lighting mode, and
can neither change the mode nor the output.
4. When the gesture-sensing function is enabled, waving a hand will only turn off the lamp temporarily.
At this time, the lamp is in a standby state, and power will still be consumed as the lamp actively awaits
commands. If the lamp will not be used for an extended period turn the rotary switch to "OFF" to save
battery power.
Intelligent Memory Circuit