Icom IC-F1500 Instruction Manual page 13

@ The calling fleet number and "GRP" appears on the
display.
@ When the call is a conference call, you can start a group
discussion.
. appears while your transceiver transmits.
*When the call is a broadcast call, you cannot tramsmit. Only
the originator can transmit.
@ The call limit timer starts count-
ing up to the called station's
pre-set time limit.
© Push to end the call and return to "READY" prompt.
© RECEIVING AN INTER FLEET OR A TELEPHONE
CALL
@ When an inter fleet call, PABX
call or PSTN call is received,
the transceiver may make a
ringing sound like a telephone.
(This function depends on your
system.) --<8 Po)
@ "CALLIFL", "CALLPBX" or
"CALLTEL" appears on the
display instead of identity num-
bers.
Inter fleet call
CALL PER
Call from PABX
OPERATION 2
@ Push §Q or push and release
[PTT] to connect the call.
*Push and hold $2) for more
than 2 sec. to reject the in-
coming call.
@ You can start a conversation.
° appears while your transceiver transmits.
© The call limit timer starts counting down to a pre-set time
limit.
®© Push ($2) to end the conversation (or wait "R-CLEAR""
appears).
* The display returns to the "READY" prompt.
—--s8 A]
CALL TEL
Call from PSTN
© RECEIVING A STATUS CALL FROM WITHIN YOUR
FLEET
@ When an incoming status
call is received, the trans-
ceiver may emit a beep.
@ The display then shows the
called station's identity and
the status message alter-
nately.
@ Push@) to return to the
"READY" prompt.
e.g. Called station's iden-
tity 37 and the incoming
status message 23 ap-
pears alternately.