AKG C 416 III User Instructions page 28

3 Using Your Microphone
(1.2-in.) pan-head bolts and nuts to fix the
microphone.
Note: To maintain the mechanical-noise attenuation
of the rubber eyelets, do not tighten the screws
hard enough to squeeze the eyelets.
Fig. 11: Adhesive
putty inserted to
prevent rattling.
Note: If you mounted the microphone on a flat sur-
Refer to fig. 11. face, insert some elastic adhesive putty be-
tween the surface and the gooseneck boss.
The adhesive putty will suppress gooseneck
vibrations and the resulting rattling noise.
B. Mounting the microphone on a flat surface
without using screws:
• Remove the backing paper from both sides of
the rubber plate and press the rubber plate
firmly on the bracket and then on the instru-
ment or speaker.
C. Mounting the microphone on an uneven sur-
face without using screws:
• Use the supplied adhesive putty instead of the
rubber plate.
Note: Both the rubber plate and the elastic putty pro-
vide the same amount of mechanical noise at-
tenuation as the rubber eyelets on the H 416.
28