EDIFIER W830NB Manual

Also See for W830NB:

Manual (7 pages)

Table of Contents

Contents

1 Power ON/OFF
2 First pairing
3 Pairing for new device
4 Dual-device connection
5 Charging
6 Controls
7 Reset
8 Wired listening
9 Documents / Resources
- 9.1 Download manual

EDIFIER W830NB Manual

Power ON/OFF

Press and hold the power button to power on/off.

First pairing

Once powered on, the headphones will automatically enter Bluetooth pairing mode.
Select "EDIFIER W830NB" in your device setting to connect.

Pairing for new device

In ON state, press and hold the " " button for about 3 seconds to enter Bluetooth pairing mode.
Select "EDIFIER W830NB" in your device setting to connect.

Note: For subsequent use, the headphones will automatically connect to the device used last time.

Dual-device connection

Pair device A with the headphones successfully.
Press and hold the " " button for 3 seconds to re-enter Bluetooth pairing mode, and then select "EDIFIER W830NB" in device B setting to connect.
Select "EDIFIER W830NB" again in device A setting to connect, and the dual-device connection is done.

Note:

Dual-device connection is disabled by default. Enable this function via the app.
For subsequent use, the headphones will automatically reconnect to the two devices used last time.

Charging

Charging the unit
Connect the headphones to a power source via the USB-C cable for charging.
Input: 5V 1A

Note:

Make sure the USB port is completely dry before charging.
When charging with a USB-C cable, the product is used as wired headphones and Bluetooth functions are unavailable.

Controls

Note:

"x 1" Press, "x 2" Double press, "—" Press and hold.
Default sound control: High Noise Cancellation / Ambient Sound / Noise Cancellation Off.
Download EDIFIER ConneX App for more customizable control settings.

Reset

Unit Reset
In ON state, press "+" and ''-'' buttons for 5s to finish reset, then headphones will automatically enter Bluetooth pairing mode if successful.