EDIFIER W210BT - Wireless Neckband Headphones Manual

Pairing

1. When they're power off, press and hold the power button for 5s. Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.

1st Pairing

1. Once the headphones are power on, they will enter Bluetooth pairing automatically. Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.

Note:
For subsequent use, the headphones will auto-connect to the device used last time.

Reset

1. The headphones are power on and disconnected from all devices.
2. Press and hold the "" and "" at the same time for 5s.
3. The status light blinks green until reset is completed.
4. Once the headphones are reset, they enter pairing mode automatically.

Controls

Note:

1. : Press and hold
2. Images are for illustrative purposes only and may differ from the actual product.

For more information, please visit our website:

www.edifier.com

@Edifierglobal

@Edifier_Global

@Edifier_Global

Model: EDF200104

Edifier International Limited

P.O. Box 6264

General Post Office

Hong Kong

www.edifier.com
2023 Edifier International Limited. All rights reserved. Printed in China

NOTICE:
For the need of technical improvement and system upgrade, information contained herein may be subject to change from time to time without prior notice.
Products of EDIFIER will be customized for different applications. Pictures and illustrations shown on this manual may be slightly different from actual product. If any difference is found, the actual product prevails.