Download Print this page

Operations And Maintenance; Safety Precautions; Maintenance Requirements; Warranty Information - Lutron Electronics Athena System Operation And Maintenance Manual

Hide thumbs Also See for Athena System:

Advertisement

Lutron Athena System Operation and Maintenance Manual

Operations and Maintenance

Safety Precautions

Safety information and / or precautions are included with each product and can also be found at www.lutron.com.
Please refer to these manuals for safety related information and instructions associated with each of the system's
components / devices.
Under no circumstances should Lutron supplied safety information and instructions supersede, or be
considered a substitute for, your local organization's electrical safety procedures.
General Safety Precautions:
• Only personnel with the proper electrical safety training qualifications should be permitted to perform
maintenance on Lutron control equipment.
• Only personnel with sufficient training on, and knowledge of, Lutron controls equipment should be permitted
to perform maintenance on this equipment.
• Always de-energize, lockout, tagout, and verify de-energized, all electrical equipment prior to performing work on
that equipment. Perform these activities only in accordance with your local site's safety procedures.
• Multiple circuits may feed some Lutron equipment. Locate and lock each supply breaker in the OFF position
before performing maintenance work. Prior to performing maintenance on de-energized Lutron equipment,
always test for the presence of voltage before beginning the maintenance work, even if you are certain that
you have completely de-energized the equipment.
• If something unexpected occurs while performing maintenance work on Lutron equipment, stop work
immediately, secure the work site, and seek help.
• Use only Lutron-approved replacement parts for easy mounting, installation, and relocation.

Maintenance Requirements

Lutron products are designed to have minimal maintenance requirements as detailed below:
Hubs
Clean the front cover as needed.
Wall Controls
Clean the front surface with a soft towel moistened with a mild soap solution (non-ammonia).
Clean approximately every six months. Do not spray cleaning solution directly on any wall control.
Any liquid entering products with line (mains) voltage may reach components, cause personal injury, damage
the equipment, and void the warranty.
Sensors
No maintenance required.
Load Controller Panels
Visually inspect installation periodically. Keep airflow clear of obstructions.
Battery-Powered Devices (Battery Replacement)
Replace batteries as needed with the correct type of battery. See the individual product installation sheet for
battery specifications.

Warranty Information

Please see the warranty enclosed with the product, or visit:
https://assets.lutron.com/a/documents/3601201a_commercial_limited_warranty.pdf
2

Advertisement

loading
Need help?

Need help?

Do you have a question about the Athena System and is the answer not in the manual?

Questions and answers