EcoFlow Smart Generator 3000 Dual Fuel Manual page 12

Bluetooth Flashing: The generator has cleared its Bluetooth pairing
2
Status information (excluding pairing with EcoFlow power stations).
Off: Bluetooth disconnected.
On: ECO mode is enabled. In this mode, the generator will
automatically adjust the RPM (Revolutions Per Minute) based
3 ECO Mode
on the power output level to reduce fuel consumption and
noise.
On: High temperature alert has been triggered. Stop
High
operation and move the generator to a well-ventilated area.
4 Temperature
The alert will automatically disappear once the temperature
Alert
returns to normal operating levels.
On: The generator requires maintenance or servicing. Visit
Maintenance
5 the EcoFlow app for detailed instructions to inspect or
Reminder
maintain the generator components.
Total Running
Time / Total
6 On: Displays total running time or total power generation.
Power
Generation
On: Engine oil alert has been triggered. Check if the engine
Engine Oil
7 oil level is sufficient. If it's low, add the appropriate amount of
Alert
oil and wait for the error code to clear automatically.
On: Low temperature alert has been triggered. The alert will
automatically disappear once the temperature returns to
Low
normal operating levels. If you need to use the generator
8 Temperature
right away, allow the generator to run without any device for
Alert
3 minutes to warm up, then connect your device to the
generator.
Flashing: Output overload alert has been triggered.
Output
Disconnect some devices connected to the generator to
9 Overload
reduce total power output. The alert will automatically
Alert
disappear once the power output returns to normal levels.
Output
10 On: Displays total output power.
Power
Internal On: Displays the battery level of the internal battery.
11 Rechargeable Flashing: The battery level is low or the battery is having an
Battery Level issue.
Operating
12 On: Displays operating power frequency.
Frequency
AC Output On: The generator has successfully started and the AC
13
Socket output sockets are available.
On: An error has occurred. Check the EcoFlow in-app
14 Error Code
instructions for troubleshooting.
On: An LPG cylinder is connected to the LPG inlet. The
15 Fuel-LPG
generator use LPG as the fuel source.
On: Displays the current fuel level. By default, this icon
displays the fuel level of gasoline and shows '88' when using
16 Fuel Level