SATO CG408 Operator's Manual page 92

Section 8: Appendix
8.2 OPTIONAL ACCESSORIES - DISPENSER (cont'd)
4.
If the paper is not taut, roll the paper on the media holder
so that the paper is taut.
Next, tightly close the pressure bracket with the liner
(backing paper) passing through it.
5.
Close the top cover until it clicks into position.
6.
After turning on the label, turn on the power.
The printer is online and the ON LINE (POWER) indicator
lights green.
When the printer is ready, press the FEED/LINE button to
output an empty label and stop at the dispenser. This
procedure is to ensure that the label is loaded correctly.
8.2.2 Stop position Adjustment
Normally, the label is dispensed to the point where 2 or 3mm (0.08" or 0.1") of the label remain on the liner
(backing paper).
If the label is not dispensed at the regular position, you can change the offset setting with the SBPL
commands. After adjusting the stop position, dispense two or three labels to fix the stop position.
Notes:
• There may be cases when the dispenser does not function properly due to the thickness of the labels
used.
• The Dispenser unit is effective for label pitch 22 to 100 mm (0.86" to 3.93"). However, the label size limita-
tion may vary with application conditions.
• Labels over 100mm (3.9") may curl at dispenser due to the nature of the material. There is no remedy for
this.
Page 8-4
Label output
from here
Output
backing
paper
CG4 Series Operator Manual