SATO CG408 Operator's Manual page 13

1.2 PARTS IDENTIFICATION (cont'd)
Internal view when Top cover is opened
15
16
17
18
19
20
21
22
CG408TT/ CG412TT
Print head
15
This component is used to print on the media.
Perform maintenance at regular intervals.
16 Ribbon unit
Used to load the ribbon and wind up the used
ribbon.
17 Pull out lever
This is used to pull out the ribbon unit from the
top cover for ribbon loading.
18 Roll media holder
To hold the roll media.
CG4 Series Operator Manual
CG408DT/ CG412DT
Media guide slide lever
19
Set to meet the size of the media used.
20 Media guide and I-Mark/ Gap sensor
A guide for the media to feed properly.
Detects the I-Mark on the media or gap of the
label.
21 Platen roller
This roller feeds the media. Perform
maintenance at regular intervals.
22
Optional device compartment
Used to install optional cutter or dispenser unit.
Section 1: Introduction
15
18
20
19
21
22
Page 1-5