Auto Setup; Unlocking A Channel - Runco Signature Cinema SC-1 Owner's Operating Manual

To unlock a channel:
1. Select Channel Setup from the Main Menu to display the Channel Setup menu.
2. The active channel should be highlighted. Press ENTER to go to the Channel Edit
submenu.
3. Select Locked from the Channel Setup menu and press ENTER to clear the check
box.
1.
2.
3.
4.
5. Auto Source
6.
7. Previous Channel
8. Next Channel
Figure 3-31. Unlocking a Channel
Use the Auto Setup feature of the SC-1 as a convenient starting point for calibrating the
projector inputs for optimum picture quality.
You cannot use Auto Setup with a locked channel; you must unlock
Note
it first. Refer to Unlocking Channels on page 58.
Auto Setup is an automated process in which the projector quickly optimizes critical
display parameters such as size, position and pixel tracking, based on the type of
incoming video signal. An Auto Setup allows you to quickly get the image "in the ballpark"
after which you can perform further calibration, if necessary.
To perform an Auto Setup, do one of the following:
On the Theater Master Remote Control: Press FUNCS, then AUTO followed by
ENTER. When the Auto Setup completes, press Enter again to keep the new settings.
On the Projector Rear Keypad: Press AUTO SETUP followed by ENTER. When the
Auto Setup completes, press ENTER again to keep the new settings.
On the DHD Controller Remote Control: Press MENU, then select Service from the
Main menu. Select Display Device from the Service Menu. Finally, select Configure from
the Display Device menu, then select Auto Setup.
What an "Auto Setup" Does: Auto Setup sets the following parameters to their default
values:
• Contrast and Brightness
• Auto Input Level (off)
• Detail (if video source)
• Filter
• Luma Delay
Runco SC-1 Owner's Operating Manual
Channel Edit
Name 16x9 night
Number 02
Input 2
In Menu
Locked
Clear this check box to unlock the channel
Sync Type: Digital Encrypted
H-Sync: 26.97 kHz
V-Sync: 23.98 Hz
Interlace: No
59
Installation

Auto Setup