Basic Operations - Aiwa CX-NA22 Operating Instructions Manual

BASIC OPERATIONS
2
+ DOWN
-UP
A EJECT
Deck 2
Use Type I (normal) tapes only.
1 Press the TAPE button and press the A EJECT
mark to open the cassette holder.
A
EJECT
Insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press the - button to start play.
Only the side facing out from the unit can be played back.
tape counter
The selected deck number
To select a playing deck
When tapes are loaded in both decks, press the TAPE button
first to select a deck.
The selected deck number is displayed.
To stop play, press the button.
To pause play (deck 2 only), press the II button. To resume
play, press again.
To fast forward or rewind, press the + or - button. Then
press the button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE button. The power is turned on and play of the
inserted tape begins.
To set the tape counter to 0000
Press the CLEAR button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
.@
@
Qo
\
.4<07
(!!>
Side A
Tab for side A
1P
To record on the tape again, cover the tab openings with
adhesive tape, etc.
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
When tapes are loaded in both decks -
After playback on deck 1 finishes, the tape in the deck 2 will
start to play without interruption and will stop at the end of the
tape. (Continuous play)
ENGLISH ~