Error Messages - Boss RC-50 Owner's Manual

Error Messages

When errors in operation occur or when operations cannot be executed properly, an error message will appear in the display.
Take the corrective measures in accordance with the message displayed.
fig.10-001d
❒
[WRITE] was pressed while playback of the Guide was in
progress.
→
Stop playback of the Guide, then press [WRITE].
❒
[WRITE] was pressed while playback, recording, or
overdubbing of a phrase was in progress.
→
Stop playback, recording, or overdubbing of the phrase, then
press [WRITE].
fig.10-090d
❒
The RC-50 could not process the data completely.
→
Lower the performance tempo.
→
Save the current content to a patch.
→
Reduce the number of adjustments or changes made with the
RC-50's knobs and pedals.
→
Reduce the number or size of MIDI messages transmitted to the
RC-50.
fig.10-002d
❒
No available recording time remains. You cannot proceed
with any further recording or overdubbing.
→
First initialize any unneeded patches or clear unneeded phrases
(p. 32), then carry out the Patch Write procedure (p. 54).
fig.10-060d
❒
The phrase cannot be played back correctly since it is playing
at a tempo significantly faster than the tempo at which it was
recorded.
→
Adjust the tempo.
fig.10-070d
❒
The phrase cannot be played back correctly since it is playing
at a tempo significantly slower than the tempo at which it was
recorded.
→
Adjust the tempo.
88
fig.10-080d
❒
MIDI messages could not be properly received.
→
Check to make sure that no corrupt MIDI messages are being
transmitted.
→
Reduce the number or size of MIDI messages transmitted to the
RC-50.
fig.10-010d
❒
There is a problem with the MIDI cable connection.
→
Check to make sure the cable has not been disconnected and
that there is no short in the cable.
fig.10-020d
❒
An excessive volume of messages were received and could not
be processed properly.
fig.10-030d
❒
Corrupt files may have been written to the RC-50 while
connected via USB (e.g., during Recover or Import).
→
Execute Factory Reset (p. 95) to restore the RC-50 to its factory
default condition.
fig.10-040d
❒
A problem has occurred with the content of the RC-50's
memory.
→
Consult your Roland dealer or local Roland Service.
fig.10-050d
❒
A problem has occurred in the system.
→
Consult your Roland dealer or local Roland Service.