Pioneer PDP-607CMX Technical Manual page 11

Connection Panel
When installing PDA-5003
INPUT3 INPUT4
S-VIDEO VIDEO
IN OUT
! @
~
When installing PDA-5004
INPUT3
S-VIDEO AUDIO
R L
^ &
COMBINATION
1
Plasma Display Section
1
COMBINATION IN/OUT
Never connect any component to these
connectors without first consulting your Pioneer
installation technician.
These connectors are used for Plasma Display
setup adjustments.
2
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker that has an impedance of 6 Ω to
16 Ω.
3
SPEAKER (L) terminal
For connection of an external left speaker. Connect
a speaker that has an impedance of 6 Ω to 16 Ω.
4
RS-232C
Never connect any component to this connector
without first consulting your Pioneer installation
technician.
This connector is used for Plasma Display setup
adjustments.
5
AUDIO (OUTPUT) (Stereo mini jack)
Use to output the audio of the selected source
component connected to this unit to an AV amplifier
or similar component.
Note: No sound is produced from the AUDIO (OUTPUT)
jack when the MAIN POWER switch is set to OFF or when
set to Standby.
AUDIO
INPUT 3/4 ANALOG RGB
R L G(ON SYNC) B R HD (H/V SYNC)
# $
COMPONENT
INPUT4
VIDEO AUDIO
VIDEO
IN OUT R L Y Pb/Cb
* ( ) _
IN OUT
RS-232C
2 3 4
INPUT5
AUDIO
VD R L
%
INPUT5
AUDIO
Pr/Cr R L
+
OUTPUT INPUT1 INPUT2
ANALOG RGB OUT
(D-Sub)
AUDIO AUDIO AUDIO
5 67 8
6
AUDIO (INPUT1) (Stereo mini jack)
Use to obtain sound when INPUT1 is selected.
Connect the audio output jack of components
connected to INPUT1 to this unit.
7
AUDIO (INPUT2) (Stereo mini jack)
Use to obtain sound when INPUT2 is selected.
Connect the audio output jack of components
connected to INPUT2 to this unit.
8
ANALOG RGB OUT (INPUT1) (mini D-sub 15 pin)
Use the ANALOG RGB OUT (INPUT1) terminal to
output the video signal to an external monitor or
other component.
Note: The video signal is not output from the ANALOG
RGB OUT (INPUT1) terminal when the panel's main power
is OFF or the panel is in Standby.
9
ANALOG RGB IN (INPUT1) (mini D-sub 15 pin)
For connection of a personal computer (PC) or
similar component. Confirm that the connection
made corresponds to the signal output from the
connected component.
0
DIGITAL RGB (INPUT2) (DVI-D jack)
Use this input to connect to a computer.
Connect to an AV component (HDCP supported)
equipped with DVI output connector.
-
AC IN
Use to connect the supplied power cord to an AC
outlet.
=
MAIN POWER switch
Use to switch the main power of the unit on and
off.
Controls and Connectors
- =
INPUT1 INPUT2
ANALOG RGB IN DIGITAL RGB
(D-Sub) (DVI-D)
9 0
11