Cooling Fan Control Setting - Pioneer PDP-607CMX Technical Manual

Plasma display monitor
Hide thumbs Also See for PDP-607CMX:
Table of Contents

Advertisement

14) Cooling Fan Control Setting

A cooling fan is located on the rear surface of the display.
This function switches the method for controlling this fan.
For automatic control according to an internal temperature sensor, Set to 'AUTO'.
For maximum rpm (AUTO CONTROL: OFF): Set to 'MAX'.
Note
The 'MAX' setting is effective for special installations.
However, since the fan rotation noise increases, the effect on the surrounding area should be taken into consideration.
For details, refer to section 3, "Installation Site Requirements" (pg. 15).
Factory setting: AUTO
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode" (pg. 142).)
2 Select 'OPTION'.
3 Place the cursor on 'FAN CONTROL' then press the [SET]
button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
3 AUTO
The 'FAN CONTROL' setting is common for all inputs.
3
MAX
Integrator Mode
Screen 3
I N T E G R AT O R
P I C T U R E
S C R E E N
F A N
C O N T R O L
O S D
F R O N T
I N D I C AT O R
C O L O R
MO D E
P R O
U S E
F R C
CHANGE
SET
I N P U T 1
S E T U P
O P T I O N
:
A U T O
:
O N
:
N O R M A L
:
O N
EXIT
MENU
163

Advertisement

Table of Contents
loading

Table of Contents