Combination Connection - Pioneer PDP-607CMX Technical Manual

5.5.3 Combination Connection

When controlling/adjusting panels, it is convenient to connect several displays to one PC.
By performing a combination connection and assigning IDs to the panels, it is possible to control and adjust several
displays at the same time or separately.
Connection method:
Connect the panels as shown in the figure below.
PC
Note
Only the combination IN terminal or the RS-232C terminal can be used at the same time. Connecting them at the
same time could cause errors. Also, do not pair combination IN terminals or combination OUT terminals. Doing so
could cause communication to fail.
It is possible to use a general-purpose mini DIN 6-pin (straight) cable for the combination cable.
Note
To output RS-232C signals from the combination OUT terminal, an ID must be assigned.
For details, refer to section, 5.5.4, "ID Assignment" (pg. 192).
First Panel
IN OUT
RS-232C
COMBINATION
OUT
Combination cable
Second Panel
IN OUT
RS-232C
COMBINATION
IN OUT
Combination cable
RS-232C Adjustment
Third Panel
IN OUT
RS-232C
COMBINATION
IN
191