Install Your Flat Panel Display
02
Follow the steps below to secure your flat panel display.
1 ) Mark locations for metal fittings and screws on the back edge of the table using the panel stand to determine
placement.
Wood screw
(commercially
available,
4 mm x 20 mm
(5/32 inch ×
13/16 inch)
min.)
2 ) Drill holes in the table or platform edge at the marked locations.
3 ) Lift panel into place with the assistance with at least one other person.
4 ) Use wood screws (not included) to secure the metal fittings to the table.
18
En
20 mm
(13/16 inch)
min.
Falling prevention
metal fitting
(supplied with the
optional stand)
(KRP-600M)