Use The Web Control System - Pioneer Kuro KRP-500M Operating Instructions Manual

Use Other Equipment With Your Flat Panel Display
6.8.2

Use the Web Control System

You can access and control the panel from the PC using a web browser. To use this option, follow the directions
below.
Display Settings
When switching browser screens, find the needed screen from the list on the left. Do not use browser buttons
and menus, such as Previous Page, Next Page, History and Bookmark. Using these buttons and menus to switch
the screens causes an imperfect screen to appear. To select a browser, follow the steps below.
1 ) Enter the obtained IP Address in the browser's address box.
2 ) Enter "admin" on the password entry screen.
3 ) Click Network
;0
Model :
******
Name :
******
Location :
******
******
Top
Detail Settings
Picture
Terminal
Functions
Network Settings
Network
E-mail
ISF
4 ) Enter information in the following fields:
• NAME
• Location
• Installation date
• LED (On/Off)
Note: To change entries other than NAME, Location and Installation date, close the browser then re-open it.
To change entries for IP Address, Subnet Mask or Default Gateway, close the browser, change the PC
network settings then re-open it.
• For browsing, use the Internet Explorer. Using any other web
browser can cause a distorted image or imperfect contents
to appear.
• From the Internet Explorer "Tools" menu, click "Internet
Options" to open the General tab. Click "Settings..." in the
"Temporary Internet Files" section to select "Every time you
start Internet Explorer" under "Check for newer versions of
stored pages:".
to begin entering settings.
NAME
Location
Installation date
DHCP
IP address
Sub net mask
Default gateway
TCP Control Port
UDP Control Port
TCP Connection limit :
LED
MAC address
Network
Web control system
:
:
:
:
ON OFF
:
:
:
:
:
OFF ON ... minutes
5
:
ON OFF
: 00:00:00:00:00:00
Set
06
69
En