Table of Contents
Advertisement
Additional information
SIRIUS radio messages
Symptom
Cause
Antenna Error
Antenna is not properly connected.
Check Sirius Tuner
SIRIUS Connect tuner is not properly connected. Check that the 8 pin mini DIN cable and AC Adapter are
Acquiring Signal
The SIRIUS signal is too weak at the current
location.
Subscription Updating
Unit is updating subscription.
Updating Channels
Unit is updating channels.
Invalid Channel
Selected channel is not available/does not exist. Select another channel.
i.LINK messages
You may see the following messages displayed in the front LCD display when using the i.LINK interface.
Message
BUS FULL
CANNOT LINK 1
CANNOT LINK 2
LINK CHECK
LOOP CONNECT
NO NAME
NO SIGNAL
PQLS OFF
PQLS ON
UNKNOWN
Meaning of messages displayed when the HDMI control function is set to ON
Message (error number)
Problem
HDMI C ERR 110 to 190
HDMI cable is not properly connected.
HDMI C ERR 1A0
HDMI C ERR 1B0
HDMI C ERR 1C0
HDMI C ERR 2C0
HOME MEDIA GALLERY messages
No.
Message
001
Content playback failed (001).
100
A communication error occurred (100).
101
No response from the server (101).
102
Disconnected from the network (102).
103
Invalid response was received from the server (103).
This format is not supported (300).
300
Authorization failed (500).
500
Explanation
The i.LINK bus has reached its capacity and cannot transmit any more data.
The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
on, switch both units off, then on again to re-establish the connection between them.
The receiver can't identify the selected i.LINK-equipped component. For example, the receiver may not be
able to identify an i.LINK-equipped personal computer.
The receiver is checking the i.LINK network. It does this when components are added to, or removed from
the network. The sound may be interrupted if this happens during playback.
The i.LINK network cannot function because the connected components form a loop. See The Input Setup
menu on page 101 for more on this.
When an i.LINK-equipped component has no name, this message is displayed instead of the proper
component name.
A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
reproduce signals from i.LINK-Audio-equipped components. See About i.LINK on page 66 for more on this.
This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Action
Check that the antenna cable is attached securely.
attached securely.
n/a
Wait until the encryption code has been updated.
Wait until the encryption code has been updated.
Remedy
• Check the connection.
• There may be a broken wire in the cable.
• This receiver or connected components may be damaged.
Problem
No details are available for the error
No further details are available for the error
Timeout period reaches due to delayed server response
Cables are disconnected
Invalid response from the server
A file that is not supported is selected
Failed to obtain WMDRM authorization
14
131
En
Hide quick links:
Advertisement
Table of Contents
