Currently Playing, Etc; Resetting The System - Pioneer Elite SC-09TX Operating Instructions Manual

Using other functions
Checking the settings of the sound

currently playing, etc.

The audio input/output information, the video input/
output information, the MULTI-ZONE status and this
receiver's setting information can be checked by
pressing the status check button on the remote control
unit. The different sets of information are divided
between four screens and displayed on the receiver's
LCD. The information shown below can be checked for
the different inputs.
SOURCE SOURCE
TV TV RCV RCV
CH VOL
VOL
1 Set the operation selector switch to RCV, then press
STATUS to check the system settings.
These appear on the front LCD display. The screen
switches between the five screens below each time the
button is pressed.
• Audio input information
DV D/ L D
STATUS AUDIO INPUT
<
AUDIO INPUT
DOLBY DIGITAL
L C
Input channel SL S
SBL SB
(( LFE ))
Input seletion
setting and input
S I GS E L : AUTO [DI G I TA L ]
singal
• Audio output information
DVD/ LD
STATUS AUDIO OUTPUT
<
AUDIO OUTPUT
Normal
Output channel L 1 2 3 4
L SLA SLB SBL
Output format
• Video input/output information
DV D/ L D
STATUS VIDEO
<
VIDEO INFORMATION
I N P U T
OUTPUT
Aspect ratio
ASPECT
setting S I G N A L IN
• MULTI-ZONE status
DV D/ L D
STATUS ZONE
<
ZONE INFORMATION
Zone 2 setting and
input
ZONE 2 ON
ZONE 3 OFF : iPod
RECOUT setting RECOUT
Note
1 The tuner status is displayed when the input is set to TUNER.
RETURN
SETUP
TUNE
CATEGORY
STATUS STATUS CH LEVEL
THX MPX MEMORY
AUTO/
- 5 5 . 0dB
>
Input signal
44 . 1 kHz
R
448 kbps
SR
DN31
SBR
Emphasiss
- 5 5 . 0dB
>
5 5 4 3 2 1 R
C SBR SRB SRA R
VSB
- 55 . 0dB
>
Input signal
: 720p / 60Hz
Output signal
:1080i / 60Hz
: 4 : 3
Terminal to which
:COMPONENT
video signal is
being input
- 55 . 0dB
>
: BD
Zone 3 setting and
: – – –
input
• This receiver's settings information
DV D /L D
STATUS SYSTEM
<
SYSTEM INFORMATION
MCACC memory
MCACC M1 : MEMORY 1
ANALOG ATT : OFF
Sleep timer
SLEEP
SR +
1
• OFF
DVD /L D
STATUS OFF
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the SETUP button on the front
panel, press  STANDBY/ON.
The display shows RESET NO.
3 Press the ENTER button on the front panel.
Select RESET using /, then press the ENTER
4
button on the front panel.
The display shows RESET? OK.
5 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
- 55.0dB
>
Analog ATT
: 28min
SR+ setting
: OFF
- 55.0dB
12
111
En