Pioneer Super Tuner IIID AVIC-N5 Operation Manual page 150

Appendix
Appendix
System detected that the ver-
tical angle of the installation
has been changed. Learning
status for Gyro Sensor has
been initialized.
System detected that the ver-
tical angle of the installation
exceeds the permission level.
Please install the navigation
unit correctly.
No data available at this time. If no data is available that can be
No XM signal. Please wait.
XM updating. Please wait.
UPDATING
Route calculation was not
possible.
Route calculation was not
possible because the destina-
tion is too far.
Route calculation was not
possible because the destina-
tion is too near.
Route calculation was not
possible due to traffic regula-
tions.
150
En
If the mounting angle of the naviga-
tion unit has been changed.
The navigation system is installed
with an extreme angle exceeding
the limitation of the installation
angle.
used with the XM tuner.
While waiting for a response from
the XM tuner.
You are in an area that cannot re-
ceive XM tuner reception.
Your current location provides very
poor reception.
Service subscription is either XM
audio only or XM NavTraffic stand
alone.
Radio is being updated with the lat-
est encryption code.
The selected channel is not in-
cluded in your subscription.
Radio is being updated with the lat-
est encryption code.
Route calculation has failed be-
cause of a malfunction of map data,
software, hardware or disc.
The destination is too far.
The destination or way point(s) are
too close.
• The destination or way point(s) are
in a Control Traffic Zone (CTR) and
the route calculation is hampered.
• Your vehicle is currently in a Con-
trol Traffic Zone (CTR) and the route
calculation is hampered.
The system initializes the sensor in order to
operate it with the maximum performance
and automatically starts re-learning.
Confirm the installation angle. (The naviga-
tion system must be installed within the al-
lowed installation angle. For details refer to
Installation Manual.)
Wait for a while and try the operation again.
Wait for a while and try the operation again.
Move into an area that can receive XM tuner
reception.
Change your location.
Since the GEX-P10XMT is capable of receiving
both XM audio and XM NavTraffic service, if
you are subscribed to only one or the other,
the system checks to see if you have added
another service to your account since you
last powered on the navigation system. When
you subscribe to both services, this message
will stop appearing when you turn the ignition
ON (ACC ON).
Wait until the encryption code is fully up-
dated.
Select another channel.
Wait until the encryption code is fully up-
dated.
• Change the destination.
• Clean the disc.
• Consult the Pioneer Local dealer if this mes-
sage persists.
• Set a destination closer to the starting
point.
• Set one or more way points.
Set a destination or way point(s) farther from
the starting point.
• Set a destination and way point(s) outside
the CTR if you know where the restricted area
is.
• Try a destination or way point(s) away from
the currently set points to some extent.
• Drive your vehicle to an unrestricted area
and reset the destination and way point(s).