Calibrating The Screen - Panasonic Toughbook CF-C1ADAAZ6M Reference Manual

Screen Input Operation
CAUTION
If a change is made to the display resolution, or the cursor cannot be pointed correctly with the pen (included), be sure
to calibrate the screen. (
When mouse drivers are installed (e.g., IntelliMouse), the screen function may not be used.
When the operation of panning (only the internal LCD) is performed while the display resolution is set higher than the
resolution of the internal LCD, the screen function will not work properly.
Even when only an external display is in use, the cursor will move on the external display if the surface of the internal LCD is
touched when the screen driver is active. Therefore, do not touch the internal LCD when only an external display is in use.
The screen function does not work in the Setup Utility.
Windows XP
The screen function does not work in the "Full Screen" of [Command Prompt].
NOTE
Do not move the pen (included) too quickly. If the pen (included) moves too quickly, the cursor may be unable to follow
its movement.

Calibrating the Screen

When you cannot point correctly with the pen (included) or your fingers, calibrate the screen by following the steps below.
A standard user needs to perform the calibration as an administrator before performing the calibration for each user.
NOTE
Rotate the display to primary landscape before performing the calibration. (
Windows 7
1
Click (Start) - [All Programs] - [Panasonic] - [Calibration Utility].
2
If [User Account Control] is displayed, click [Yes].
3
<Only for model with digitizer>
Click [Pen input (digitizer)] or [Touch input].
<Only for model with touchscreen>
Click [Start].
If you add a check mark for [Advanced calibration], detailed adjustment can be performed.
below)
15
page 20).