1. DESCRIPTION PLEASE READ THIS MANUAL CAREFULLY. 1.1 TECHNICAL CHARACTERISTICS. Motor: Pump: . . . 75 2 1 2 75 2 1 2 2. SAFETY INSTRUCTIONS PUMP. CAREFULLY READ AND FOLLOW ALL SAFETY INSTRUCTIONS PROVIDED IN THE MANUAL AND INDICATED ON THE UNIT. 2.1 MANUAL SAFETY SYMBOLS.
Page 4
NOTICE 4 44 2.2 IMPORTANT SAFETY INSTRUCTIONS. WARNING CAUTION Dangerous pressure levels. Incorrect installation of this unit can WARNING cause serious injury or damage to the installation. 2.3 RATING PLATES. “1.1. TECHNICAL CHARACTERISTICS AND CHARACTERISTICS AND DIMENSIONS”. 2.4 RESPONSIBILITY. 2.5 REGULATIONS. 2 6 42 2 4 1 2 6 5...
“1.1.TECHNICAL CHARACTERISTICS”. 4 44 4 44 4 44 4 44 4 44 4 44 will release 4 44 DANGER This apparatus is not a toy. DANGER Ensure that children do not play with it. 3. PACKAGING, TRANSPORTATION AND STORAGE ATTENTION ATTENTION ATTENTION...
5.2 ELECTRICAL PROTECTION. See section 10. ”TABLE OF CONDUCTORS AND CIRCUIT BREAKERS”. 5.3 ELECTRICAL CONNECTION. DANGER 4 44 Never connect the power supply using the factory testing cables. See chapter 10. To change the rotation direction...
6. PUMP HYDRAULIC REQUIREMENTS The suction of the pump is dangerous and can trap and even WARNING drown swimmers. Never use or allow anyone else to use a pool, spa or water feature unless there are at least two inputs on each pump intake line.
75 2 7. COMMISSIONING 7.1 PUMP PRIMING. Never run the pump when dry. WARNING DO NOT START THE PUMP. (see Figure 1) . To change the rotation direction...
7.2 MAINTENANCE. Disconnect the power before performing any maintenance task on the pump. 4 44 . Never hit Never use solvents. Do not place chemical products inside the pre-filter. Remember, all changes to the position of the selector valve or the valve manifold of the filter must be made when the pump is stopped.
8. DISASSEMBLY / ASSEMBLY 8.1 DISASSEMBLY. CAUTION 4 44 Close all valves before performing any operation. (POINT 12. EXPLODED VIEW DRAWING). 8.2 ASSEMBLY. ALL PARTS TO BE COUPLED DURING ASSEMBLY MUST BE CLEAN AND IN PERFECT CONDITION.
9. TROUBLE SHOOTING POSSIBLE CAUSE SYMPTOM 1. ELECTRICAL 2. MECHANICAL 3. INSTALLATION CAUSE POSSIBLE ORIGIN 1. ELECTRICAL 1. 1 THE INSTALLATION HAS NO POWER 1. 2 THERE IS NOT POWER ON A PHASE 1. 3 LOW MOTOR VOLTAGE 1. 4 INCORRECT MOTOR CONNECTION 1.
SYMPTOM POSSIBLE CAUSE 2. MECHANICAL 2. 1 OBSTRUCTED FLOW 2. 2 THE PUMP DOESN’T PRIME 2. 3 INTERNAL LEAKS 2. 4 MISSING PARTS 3. INSTALLATION 3. 1 THE PRESSURE REQUIRED FOR INSTALLATION IS HIGHER THAN THE PUMP PRESSURE 3. 2 OBSTRUCTIONONTHEINTAKE 3.
Need help?
Do you have a question about the HCP3600 Series and is the answer not in the manual?
Questions and answers