Tv Format Setup (Not American Models) - Onkyo TX-SR602 Instruction Manual

First Time Setup —Continued

TV Format Setup (not American models)

Here you can specify the TV format used in your area.
1 Press the [RECEIVER] button fol-
RECEIVER lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "1. Initial
Setup," and then press [ENTER].
The Initial Setup menu appears.
3
Use the Up and Down [
buttons to select "3. Hardware
Setup," and then press [ENTER].
ENTER
The Hardware Setup menu appears.
Menu
------------------------
Basic Setup
1.Initial Setup
1.Initial Setup
------------------------
2.Speaker Setup
1.Digital Input
1-3.Hardware Setup
ENTER
2.Component Video ------------------------
Advanced Setup
3.Hardware Setup a.Powered Zone2
3.Surround Setup
4.Audio Adjust
b.Sp Impedance Minimum
5.Listening Mode Preset
6.Preference
c.TV Format
d.AM Frequency Step
(Menus vary depending on country.)
4
Use the Up and Down [
buttons to select "c. TV Format,"
and then use the Left and Right
ENTER
[ ]/[ ] buttons to select:
Auto: Conforms with the video
input signal.
PAL: Select if the TV system in
your area is PAL.
NTSC: Select if the TV system in
your area is NTSC.
5
Press the [SETUP] button.
The setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
AM Frequency Step Setup
(some models only)
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
1
]/[ ]
2
]/[ ]
3
:Not Activated
:6ohms
:NTSC
: 9kHz
]/[ ]
4
5
Note:
• This procedure can also be performed on the AV
Press the [RECEIVER] button fol-
RECEIVER lowed by the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [
buttons to select "1. initial
Setup," and then press [ENTER].
The Initial Setup menu appears.
Use the Up and Down [
buttons to select "3. Hardware
Setup," and then press [ENTER].
ENTER
The Hardware Setup menu appears.
Menu
------------------------
Basic Setup
1.Initial Setup
1.Initial Setup
------------------------
2.Speaker Setup
1.Digital Input
1-3.Hardware Setup
ENTER
2.Component Video ------------------------
Advanced Setup
3.Hardware Setup a.Powered Zone2
3.Surround Setup
:Not Activated
4.Audio Adjust
b.Sp Impedance Minimum
5.Listening Mode Preset
6.Preference
c.TV Format
d.AM Frequency Step
Use the Up and Down [
buttons to select "d. AM Fre-
quency Step," and then use the
ENTER
Left and Right [
select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if 9 kHz steps are used
in your area.
Press the [SETUP] button.
The setup menu closes.
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
]/[ ]
]/[ ]
:6ohms
:NTSC
: 9kHz
]/[ ]
]/[ ] buttons to
45