Onkyo TX-SR602 Instruction Manual page 50

First Time Setup—Continued
Speaker Level Calibration
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Notes:
• The speakers cannot be calibrated while the output of
the AV receiver is muted, while a pair of headphones
is connected, or when using the multichannel input.
• Because the TX-SR702/702E supports THX, the
test tone is output at the standard level of 0 dB
(absolute volume setting 82). If you normally listen
at volume settings below this, be careful because
the test tone will be much louder.
1
2, 3
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [ENTER].
ENTER
The Speaker Setup menu appears.
ENTER
50
3
ENTER
ENTER
4
ENTER
2–4
1, 6
5
6
]/[ ]
Notes:
• This procedure can also be performed by using the
remote controller. First press the [TEST TONE] but-
ton to output the test tone. Use the [LEVEL–] and
[LEVEL+] buttons to set the volume, and use the [CH
SEL] button to select the speakers.
Use the Up and Down [ ]/[
buttons to select "3. Level Cali-
bration," and then press
[ENTER].
The Level Calibration menu appears
and the pink noise test tone is output by
the front left speaker.
Menu
------------------------
Basic Setup
2.Speaker Setup
1.Initial Setup
------------------------
2.Speaker Setup
1.Speaker Config
2-4.Equalizer Settings 2-3.Level Calibration
------------------------ 2.Speaker Distance
Use Settings :Manual
Advanced Setup
3.Level Calibration a.Left : 0dB
------------------------
3.Surround Setup
4.Equalizer Settings
b.Center Left : 0dB
4.Audio Adjust
a. c.Rught 80Hz : : 0dB 0dB
5.Listening Mode Preset
b. 250Hz d.Surr Right : : 0dB 0dB
6.Preference
e.Surr Back R c. 800Hz : : 0dB 0dB
d.2.5kHz f.Surr Back L : : 0dB 0dB
g.Surr Left e. 8kHz : : 0dB 0dB
h.Subwoofer : 0dB
Note:
Speakers that you set to No or None on
the Speaker Configuration page
(page 46) cannot be selected.
Use the Up and Down [ ]/[
buttons to select each speaker,
and use the Left and Right [
[ ] buttons to set the volume.
The volume can be adjusted from –12
to +12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
Repeat step 4 until the volume of
the test tone from each speaker
is the same.
When using a handheld Sound Level
Meter, calibrate each loudspeaker
channel (Left, Center, Right, Right Sur-
round, Surround Back Right, Surround
Back Left, Left Surround, and Sub-
woofer) to 75 dB SPL at the listening
position, measured with C-weighting
and slow reading.
Press the [SETUP] button.
The setup menu closes.
]
]
]/