Set-Up And Operations - Simpleway NNOUNCE micnode mini Hardware User's Manual

micnode mini – Hardware User Guide
Desk-stand
The micnode mini microphone station base attaches to
the device with two screws. Before attaching the device
to the stand, connect all paging station cables on the rear
panel, and put the cables through the stand.

SET-UP AND OPERATIONS

The micnode mini device utilizes Power over Ethernet (PoE). Therefore, begin by connecting the device to your network with
a LAN cable and then proceed to establish the network connection. Access the nnounce configuration UI to define the LAN
setup. If you are incorporating your mini station within a Q-SYS installation, you will perform further steps in the Q-SYS
designer and download the micnode mini plugin. This configuration is auto populated to the nnounce ecosystem and
micnode mini station and vice-versa. To complete your configuration, set up streams and define zones for your paging
buttons.
Connect the Device
Connect your micnode mini device to your network.
CAUTION: The device uses power over ethernet (PoE).
1. Connect the device with the LAN port.
2. Connect the device to the network, with DHCP enabled.
3. Use a computer with an Internet browser and search for your micnodemini device by typing into the
computer URL https://micnode-mini- and the last 6 digits of the MAC address of your device, which you can
find on the product sticker of your device.
•
Example: https://micnode-mini-000000 or https://micnode-mini-000000.local
TM
nnounce by Simpleway
NN_USER_GUIDE_micnodeMINI_v1.1.docx
6