Connecting To A Pc With A Usb Cable; Installing Usb Driver Manually - Mpio FY 600 User Manual

Connecting to a PC

Connecting to a PC with a USB Cable

1 Connect FY600 to the PC with the USB cable as shown image.
If the USB cable is disconnected from the PC during the initial USB driver installation or in middle of a command,
it may malfunction.
The USB Driver will be installed with a message indicting "Looking for a New Device" The installation screen
2
may not appear. Check the Device Manager to confirm the installation.
Confirming USB Installation
Windows 98/ME:
[Control Panel] → [Systems] → [Device Manager] →
[Hard Disk Controllers]→ MPIO FY600 USB Device
Windows 2000/XP:
[Control Panel] → [Systems] →[Hardware]→[Device Manager]
→[Disk Drives]→ MPIO FY600 USB Device
Note
If the system operating under Windows 98/98SE doesn't connect with FY600 automatically, install the
USB Driver manually by referring to "Installing USB Driver Manually".
Connect with a USB Cable

Installing USB Driver Manually

Please refer to the below only if the device is not plugged with Windows 98/98E.
Connect FY600 with a computer with the USB
1
cable. When "Add New Hardware Wizard" window
appears on the screen as shown in right, click the
[Next] button.
2 Check "Search for the driver for your device",
click the [Next] button.
Click

Click
