Play Mode; Display In Play Mode - Mooer OCEAN MACHINE II Owner's Manual

Looper mode:
The Ocean Machine II features two main operation modes for using the delay and reverb effects in
different ways plus a Looper Mode.
Press the Preset button to change the main mode of operation. The blue LED in the Preset button is
unlit in Play Mode and lit in Patch Mode.
When booting up, the pedal will remember the mode it was in before it was turned off (power supply
removed).

Play Mode

In this mode the Ocean Machine II operates like a traditional effects pedal. You can use the Reverb,
DelayB and DelayB footswitches as if the effects were individual pedals. The footswitch LED indicate
whether the respective effect is ON or OFF.
The values of the main effect parameters correspond to the settings indicated by the physical knobs.
For some effect types, additional parameters can be set using the Menu button. These are indicated
only in the display. (See section When the main interface (Play or Patch Mode) is displayed, rotate
the Menu control to adjust the master output effect mix of the Ocean Machine II (ratio of the effect
signal / dry signal).
Parameter screen)
All of the basic effect parameters can be changed directly by adjusting the respective control knobs.
Additional effect parameters, tempo subdivisions, ping pong effects, sequence of the effects chain,
etc. can be edited and adjusted in the menu screen. (See section Menu control)

Display in Play Mode

Effects chain
Shows the sequence of the
effect blocks and the
current status of each effect
PingPong
Use the Menu control to
select and activate the
PingPong effect for each of
the Delay effect blocks.
DelayB Time DelayA Time
Delay Tempo
Use the Menu control to select
and edit tempo subdivision
values and status.
Effect Block
Each Effect has its own effect block
which displays the effect type, status
and the position in the effects chain.
Some effect types such as Mod-Rev
have additional parameters which can
be edited by accessing the effect block.
Select an effect block using the Menu
control and the effect block parameters
will be displayed.
9