11 Decommissioning
11.1 Disassemble the Inverter
Remove DC input line and AC output line of inverter.
Ÿ
Wait for at least 5 minutes to power off.
Ÿ
Remove all cable connections from the inverter.
Ÿ
Remove inverter from nger support the bracket.
Ÿ
Remove the bracket if necessary.
Ÿ
Load the inverter into the original package if possible.
Ÿ
11.2 Packing
Load the inverter into the original package if possible.
Ÿ
If the original package can not be found, you can also use the
Ÿ
following requirements of the carton packaging:
Ÿ
Bearing capacity of more than 30 kg.
Ÿ
Easy to carry.
Ÿ
Can completely seal the cover.
Ÿ
11.3 Storage and Transportation
Store the inverter in a dry, temperature -40°C~70°C
Ÿ
environment.
Ÿ
Pay attention to less than four machines on each stack board
Ÿ
during storage and transportation.
Ÿ
11.4 Waste Disposal
If it is necessary to scrap the inverter or other related parts, be
Ÿ
sure to send the waste inverter and packaging materials to the
Ÿ
designated location for recycling by the relevant department.
Ÿ
42
12 Disclaimer
The GT1 2.5~10kW series grid-tied inverters are transported, used and
operated under limited condition, such as environmental, electrical etc.
Livoltek shall not be liable to provide the service, technical support or
compensation under conditions listed below, including but not limited to:
. Inverter is damaged or broken by force majeure (such as earthquake,
ooding, thunderstorm, lighting, re hazard, volcanic eruption etc.).
. Inverter's warranty is expired and doesn't buy extended warranty.
. Can't provide the inverter's SN, warranty card or invoice.
. Inverter is damaged by man-made cause.
. Inverter is used or operated against any items in local policy.
. Inverter's installation, conguration, commissioning doesn't follow the
requirements mentioned in this manual.
. Inverter is installed, retted or operated in improper ways mentioned
in this manual without authority from Livoltek.
. Inverter is installed, operated under improper environment or electrical
condition mentioned in this manual without authority from Livoltek.
. Inverter is changed, updated or disassembled on hardware or software
without authority from Livoltek.
. Obtain the communication protocol from other illegal channels.
. Build monitoring, control system without authority from Livoltek.
. Livoltek will keep right to explain all the contents in this user manual.
43
Need help?
Do you have a question about the GT1-2K5D2 and is the answer not in the manual?