Kyocera KM-2530 Operation Manual page 77

4. Selecting the Printer Settings
4-3 Emulation Protocol settings
About the emulation protocol settings
It is possible to perform emulation protocol settings for the 6 items shown in the following chart.
For the most efficient use of the printer functions, select the various settings according to your printing needs.
1
Selecting the emulation
Sets the emulation protocol.
2
Code set
Selects the code set that will be used under each
emulation protocol.
3
KPDL Error Report print out ON/OFF
When the emulation protocol has been set to KPDL or
KPDL (Auto), sets whether an Error Report will be auto-
matically printed out whenever a KPDL error occurs.
4
Auto emulation switching
Sets the back-up emulation mode when the emulation
protocol has been set to KPDL (Auto).
5
KC-GL Page
Selects the paper format when the emulation protocol has
been set to KC-GL.
6
KC-GL Pen
Selects the type and width of the pen when the emulation
protocol has been set to KC-GL.
Item Available settings
PCL6, Line Printer,
IBM Proprinter, DIABRO 630,
EPSON LQ-850, KPDL,
KPDL (Auto), KC-GL
The code sets that are available
for selection will differ depending
upon the emulation protocol.
OFF, ON
PCL6, Line Printer,
IBM Proprinter, DIABRO 630,
EPSON LQ-850, KC-GL
A2, A1, A0, B3, B1, B2, B0, SPSZ
01 – 99
4-8
Remarks
Allows you to set a different emula-
tion protocol for each interface.
Select "ON" to have an Error Report
printed out and "OFF" not to have
any Error Report printed out.