Kyocera KM-2530 Operation Manual page 73

4. Selecting the Printer Settings
G Selecting the serial interface settings
Select "Serial" and then touch the "Detail" key. The [Serial] screen
1
will appear.
Use the "L" and "M" cursor keys to select the desired item and then
2
touch the "Change" key. The setting screen for the selected item will
appear.
Baud rate: Sets the Baud Rate 3.
Data Bits: Sets the data bit length 4.
Stop Bits: Sets the stop bit length 5.
Sets the parity 6.
Parity:
Protocol: Sets the protocol 7.
Barcode: Turns the barcode mode ON/OFF 8.
Select the desired setting for each item and then touch the "Close"
3
key. The display will return to the [Serial] screen.
G Selecting the network interface
Select "Network" and then touch the "Detail" key. The [Network]
1
screen will appear.
Use the "L" and "M" cursor keys to select the desired item and then
2
touch the "Change" key. The setting screen for the selected item will
appear.
Turns NetWare ON/OFF 9 and selects the
Netware:
NetWare Frame type 0.
Turns TCP/IP ON/OFF !, DHCP ON/OFF @
TCP/IP:
and sets the IP address #, Subnet Mask $
and the Gateway address %.
Selects the Ether Talk setting ^.
Ether talk:
Option Status Page: Selects the setting for the Network Card Status
Page print out &.
4-4