Display Panel; Battery Charging Profile; Solar Priority - iTechworld iTECHDCDC25 User Manual

DISPLAY PANEL

MODE
STD GEL AGM CAL LiFePO4
Alternator
Solar
Solar
Priority
Fault

BATTERY CHARGING PROFILE

To modify the battery charging profile, press the 'Mode' button for 1.5 seconds. As a
result, the battery type indicator will move one LED to the right.
Please be aware that following any changes there may be a delay of 2 minutes
before the charger starts the charging process.

SOLAR PRIORITY

The iTECHDCDC40 and iTECHDCDC25 are set up with alternator priority as default,
as the power from solar can be very unstable, which thus affects charge efficiency.
If you prefer solar charging regardless of its charging efficiency, or your auxiliary
battery has a small load connected and you want to use solar charging as much as
possible, you can enable the "Solar Priority" function. The iTECHDCDC charger will
now always select input power from the grey Anderson (solar) if the solar input is
above the minimum required power. Please note it may take up to 2 minutes after
any changes for the charger to begin charging.
To turn "Solar Priority" ON, please press and hold the "Solar Priority" button for 1.5
seconds, then release – the indicator will turn on.
To turn "Solar Priority" OFF, please press and hold the "Solar Priority" button for 1.5
seconds, then release – the indicator will turn off.
5